16 Jun
2001
16 Jun
'01
12:37 p.m.
I am trying to set up a Compaticard II Rev D as a secondary FDC, but I
don't have the documentation. Anyone have a scanned copy of the manual?
The Micro Solutions Web page does not have it online!
The only parts I can figure out is the interrupt jumper on the card,
and the drive type number on the ccdriver.sys command line. On the card
why are there 2 sets of jumpers for I/O address and 2 sets of jumpers for
DMA? I know that my primary FDC is at IRQ6 and DMA2. Do I have to jumper
my Compaticard to both different IRQs and DMAs?
Thanks for your help,
Edwin
16 Jun
16 Jun
4:05 p.m.
On Sat, 16 Jun 2001, Edwin P. Groot wrote:
I am trying to set up a Compaticard II Rev D as a
secondary FDC, but I
don't have the documentation. Anyone have a scanned copy of the manual?
The Micro Solutions Web page does not have it online!
The only parts I can figure out is the interrupt jumper on the card,
and the drive type number on the ccdriver.sys command line. On the card
why are there 2 sets of jumpers for I/O address and 2 sets of jumpers for
DMA? I know that my primary FDC is at IRQ6 and DMA2. Do I have to jumper
my Compaticard to both different IRQs and DMAs?
I do npt have the manual for the CompatiCard II; however, the
CompatiCard IV manual says that you need not pick alternate values
unless it chokes on sharing the system's values. Good luck!
- don
Thanks for your help,
Edwin
8592
days inactive
8592
days old
1 comments
2 participants
participants (2)
-
donm＠cts.com -
epgroot＠ucdavis.edu