10 Jun
2014
10 Jun
'14
6:50 p.m.
Hey folks. I've been noodling on this for a bit and it may be
obvious, but I'm completely missing it. Is it possible in PCB to make a
plated-through hole, in contact with copper planes on both the top and
bottom of a board, without a thermal?
Thanks,
-Dave
--
Dave McGuire, AK4HZ
New Kensington, PA
10 Jun
10 Jun
7:08 p.m.
On Jun 10, 2014, at 15:50 , Dave McGuire <mcguire at neurotica.com> wrote:
Hey folks. I've been noodling on this for a bit
and it may be
obvious, but I'm completely missing it. Is it possible in PCB to make a
plated-through hole, in contact with copper planes on both the top and
bottom of a board, without a thermal?
Which circuit board layout program are you using?
--
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/
7:50 p.m.
On 6/10/2014 6:08 PM, Mark J. Blair wrote:
On Jun 10, 2014, at 15:50 , Dave McGuire <mcguire
at neurotica.com> wrote:
I do it all the time in EAGLE.
create a via of the appropriate size and then rename it to the copper
plane's name.
JIm
--
Jim Brain
brain at jbrain.com
www.jbrain.com
Hey folks. I've been noodling on this for
a bit and it may be
obvious, but I'm completely missing it. Is it possible in PCB to make a
plated-through hole, in contact with copper planes on both the top and
bottom of a board, without a thermal?
Which circuit board layout program are you
using?
3699
days inactive
3699
days old
2 comments
3 participants
participants (3)
-
brain＠jbrain.com -
mcguire＠neurotica.com -
nf6x＠nf6x.net