Hi Eric.
Yes, very strange indeed.
The G7273 is placed in slot positions C & D, the correct way.
Edward suggested to use the Ohmmeter and check for a very fine
disconnect on the etch of the G7273. The etched wire is indeed
quite thin, I remember from yesterday.
We'll see this evening ...
- Henk.
-----Original Message-----
From: Eric Smith [mailto:eric@brouhaha.com]
Sent: dinsdag 16 juli 2002 10:43
To: cctalk(a)classiccmp.org
Subject: RE: help needed: problem with UNIBUS access on my PDP-11/70
However ... (I will check this again)
RX11 in slot 41 --> hung and we know why.
RX211 in slot 41 --> all OK and we know why.
G7273 double grant in slot 41 --> THE HUNG IS BACK! Huh??
Very strange. You've got the G7273 in the right slots (C&D)? And
not upside-down? If it's inserted correctly, it can't help but pass
the grants through!