At 11:04 AM 6/25/98 -0700, you wrote:
On Thu, 25 Jun 1998, Allison J Parent wrote:
<I've also learned that the printed
circuit boards were 2-sided, but had n
<plated-thru holes. This may have caused problems to IC solder connections
<making reliability problems. I don't know if this would make buyers aband
<them making the numbers larger or smaller than otherwise.
Not a problem. The trick was to solder both sides ot use through wires
as needed. It made the board much cheaper and buildable by home brewers.
And that approach is cheaper and easier than the tubular rivet that
preceded plated through holes - if you could even find such today :)
Yes, using wires as jumpers is good too. I'm amazed in TV sets, stereos,
etc. most all the printed circuit boards are one sided. The problem
I saw was with the actual IC pins. Sockets would make it worse.
If you don't plan ahead, there might be not enough lead to solder
to on the component side of some disk capacitors (resistors mounted
on end?), etc.
-Dave