Someone can make a picture of a KDA50 cab kit please? - test-drb@ccmp.vtda.org

12 Mar 2002

...
  Doug Carman wrote:
Gunther Schadow wrote:

> I guess so. I personally have a uVAX-II in the small cabinet, but
> I take anything, I don't care about the larger metal pieces, what
> I care about is the cable to the card and the SDI connectors. Those
...
 > should be the same. I need the picture so a guy
who doesn't know
> these things but may have the cables in a pile of stuff can recognize
...
   it. 
I have the cable kit for the BA200 series cabinets as well.  You are
...
 right, it will work in a BA123 if you just route the
pigtails out a hole
...
 in the rear bulkhead.  The part number for the one I
have is
17-00951-03.  It has a 32 pin Berg connector on the module end with a
...
 funny flat plastic retainer that holds it in.  The
pigtails are about 30
...
 inches long and each has the metal 8 pin connector that
mates to the
...
 disk drive cables. 
	The KDA50 User Guide is at:
       http://208.190.133.201/decimages/moremanuals.htm

	The BA23 cab kit is pictured on p2-2.
	It's basically a rectangular panel with two
	connectors for SDI cables. The internal
	cable just plugs in on the inside (and the
	external cables - somehwhat thicker)
	plugs in externally. You need two bulkheads
	if you want to use all four possible
	drives. The internal cable is four tails
	connected to a single flat head with
	a plastic cover at the KDA50 end. (It's not
	*that* clear from the picture unless you
	already know what you are looking at).
	More pictures on pp 2-14, 2-15 and 2-16.

	I cannot find a picture of the BA213 arrangement.
	The KDA50 board pair sits behind a three-wide
	metal panel (the third slot is occupied by the
	cabling). The internal cable is the same and heads
	up and to the top left drive bay. There is where
	the bulkhead lives ... a recessed four-way
	connector. I expect I'll find a picture
	as soon as I hit "Send" ...

	Antonio