Please be careful with this! Have quite some experience in building three phase inverters from such small boxes for my various avionics projects. (1) The normal ones rectify the mains voltage (in EU this gives around 320V DC) and from this make PWM outputs on three lines. Yes, you can enter voltage and frequency (sometimes even more than 400Hz) digitally, but the outputs are ALWAYS PWM switching between 0V and 320V in the EU. Consequence: If you rectify these outputs you will get back your 320V, completely independent of your settings! You need to use a device called Sinus-Filter, i.e. a low pass using caps and Ls to smooth out and get rid of the PWM - only than you get the correct three phase. (2) The small boxes are only for motors (inductive loads). Connecting someting else (does not matter whether three phase or not) which e.g. has got EMC filters at the input containing caps, the relatively high frequency (e.g. 16kHz, often selectable) will easily toast them leading to a short. (3) The PWM-boxes do not isolate from mains, so you will have pretty high voltages at the PWM outputs with high frequencies which can be a challenge for isolations - so even if you set the inveter to 110V only, but power it 320V! My biggest inverter based on such a small PWM motor drive inverter is described in my blog (including schematics)... http://www.baigar.de/TornadoComputerUnit/TimeLine.html#inverter1500 (4) DO NOT use these three phase boxes connecting one output and one input pin to your device thinking that this is a single phase output. Creating a "neutral" line at the output of such an inverter can be done, but it requires additional components and than you can use it as single phase device: Here I used a special transfomer after the Sinus filter with input in triangle and output in star configurations. So I get neutral PLUS insulation to mains... Good luck!