14 Jul
1999
14 Jul
'99
10:05 p.m.
I just aquired a uVAXII with a RD54 and a TK50 drive and I'm trying to load
VMS. I don't remember the stand-alone backup command to issue. I'm hoping
that someone can help.
I have two TK50 tapes that came with it. They are labeled:
VMS V5.0 BIN TK50
BINARY
and
VMS V5.0 BIN TK50
MANDATORY UPDATE
I can probably handle the update after I install VMS (something like
@SYS$UPDATE:something-or-other).
The first tape boots and takes me into stand-alone backup. At that point I'm
lost. Any ideas?
Thanks,
Bill
15 Jul
15 Jul
10:22 a.m.
---- Original Message -----
From: William King <wrking(a)tsoft.com>
To: Discussion re-collecting of classic computers
<classiccmp(a)u.washington.edu>
Sent: Wednesday, July 14, 1999 9:05 PM
Subject: VMS 5.0 & stand alone backup
I just aquired a uVAXII with a RD54 and a TK50 drive
and I'm trying to
load
VMS. I don't remember the stand-alone backup
command to issue. I'm hoping
that someone can help.
I have two TK50 tapes that came with it. They are labeled:
VMS V5.0 BIN TK50
BINARY
and
VMS V5.0 BIN TK50
MANDATORY UPDATE
I can probably handle the update after I install VMS (something like
@SYS$UPDATE:something-or-other).
The first tape boots and takes me into stand-alone backup. At that point
I'm
lost. Any ideas?
Hi Bill,
the more or less general format is:
backup source: target:
in your case, it should be something like:
BACKUP/IMAGE/VERIFY TAPEDRIVE:VMS50.B/SAVE_SET YOURDISK:
where you should put the realnames of your tape drive, you disk & the name
of the save set.
The names of tape & disk you can see during boot.
hope it helps,
emanuel
9310
days inactive
9311
days old
1 comments
2 participants
participants (2)
-
emu＠ecubics.com -
wrking＠tsoft.com