At 02:11 PM 7/13/97 -0800, you wrote: The C=128 does not need any kind of bootfloppy, it will start up in C=128 mode. if you type GO64, it reverts to a C=64 kernal. and if you want to run CPM, then you need a CPM boot disk, however it is not required to run the machine. this is what I liked about the 128, 3 mahcines in 1! :) for your monitor, the 128 has RF output accessable from the RCA jack, a 5 pin DIN video connector that provides composite, or seperated video plus sound. also there is a RGB 9 pin DSUB connector so you can use ANY CGA monitor for 80 col. for the 1702, you need a video cable(looks like you have this), and use the separated mode for sharper graphics. the buzzing you hear is because you have connected the video out RCA jack to the audio in. You should have 5 phono plugs on the end of the video cable, and a din plug on the other. just experament with all the plugs till it works. the video plug colors usually (but not always) YELLOW - sound RED Video chroma WHITE video Luminace BLACK SOUND GRAY Composite video each manufacturer used different color chemes, and this might be wrong for other cables than mine. also the 1702 has a front panel switch that has 3 positions: 1- monochrome this just makes everything green used for composite video 2- Composite video this is just the standard video in, you can hook your VCR to it for a nice sharp TV!! 3- seperated - this uses seperate lines to feed the video, and this has the best quality Nope. unless you want to run CPM shore will. if it is potted, NOPE. some are unpotted and can be fixed. I have these manuals too and I must say that it leaves no tern left unstoned.