Never mind, I just realised there was a little "+" sign well away from the symbol that allowed me to select it. It looks like the symbol is somehow much bigger that how I have drawn it. I should be able to work it out now. Regards Rob From: Rob Jarratt <robert.jarratt at ntlworld.com> Sent: 07 March 2020 17:12 To: General Discussion: On-Topic and Off-Topic Posts (cctalk at classiccmp.org) <cctalk at classiccmp.org> Subject: Can't Select a Custom Device in Eagle I have been using Eagle to reverse engineer a PSU schematic. I decided I needed to make a custom device in Eagle for the transformer. I have done this and it seems to be fine, except that when I put the symbol on a schematic, after I have confirmed its position, I can't select it, so I can't move it or anything. I have done some web searches but I can't find anything about this. Anyone know what the problem might be? I am using the free version, and I am on version 7.2.0. Looks like later versions are subscription only and I am reluctant to do that because they could take away access at any time. Thanks Rob