In a message dated 9/23/2003 8:03:15 AM Eastern Daylight Time,
r_beaudry(a)hotmail.com writes:
<< > Is it possibl;e to modify a standard IBM 3.5 inch FDD to
work with the apple??
As other pointed out, no....
I understand the Apple II uses a
special drive interface, can this be conected up to the 3.5 inch drive
hardware and be used to drive them??
You can't hook up a Disk II or 5.25" controller to a 3.5" disk drive..
However, a 3.5" drive can be used in an Apple IIe (not sure about II, II+).
There are two possible combinations:
- Apple sold a drive called a UniDisk 3.5. This drive had a processor and
buffer memory inside the case to allow it to buffer and effectively slow
down the data transfer rate to the point where the Apple IIe could handle
it. You still need to get a special controller card (often referred to as a
"LIRON" card, because the word was silkscreened on the card).
>
There was also a controller card called the
UDC made by Laser computer (IIRC)
that could run various combinations of 5.25 and 3.5 drives. Shouldve got one
back then.