114 (7 inch diameter reel, 25 ips max speed) 9 (9 track) - 86 (800/1600 bpi) - 2 (again, 25 ips) - 240 ( 240 volts ac) - Fp (PE only) The manual shows 6 connectors on the bottom of the unit, probably inside. These are labelled J1 through J6. J1,J2 are motor control. J3, J4 are read card. J5,J6 are write/control card. J1,J2 are closest to front. On the top edge of the write/control card (closest to rear) are the two fifty-pin I/O connections. The manual says nothing about JA through JD. Perhaps it is an add-on formatter, which is not detailed in the manuals. Hope that helps, but I don't see how. Nothing matches for connectors. Joe Heck Andreas wrote: Subj: Digi-Data corporation Tape drive docs sought Hello all, I got a Digi-Data Corporation, Model 1149-86-2-240-FP, Tape-Drive. I'm interested in any kind of documentation, esp, how to connect this tape to an Emulex TC02 tape-controller. The tape-controller has two connectors labeled J1 and J2, the tape-drive has four connectors, labeled JA to JD, so there are multiple choices while tring to connect the tape-drive, so I need some help! Andreas