17 Nov
2005
17 Nov
'05
7:21 a.m.
I have a wire that is broken on the Berg connector that plugs into my
DLV12 controller for my RL01 drive. How do I remove one of the pins
from the Berg connector so that I can reattach the
broken wire? Is it
possible to repair these connectors or do I have to replace it?
1 Dec
1 Dec
11:07 a.m.
New subject: RLV12 located with cable
David Betz wrote:
I have a wire that is broken on the Berg connector
that plugs into my
DLV12 controller for my RL01 drive. How do I remove one of the pins
from the Berg connector so that I can reattach the broken wire? Is it
possible to repair these connectors or do I have to replace it?
Sure enough, I finally found my RLV12 with the ribbon cable and
adapter. I noticed your email about getting it running already, so does
that mean you don't need a cable any more?
The RLV12 was at a customer site that I had already looked at, but
apparently not thoroughly enough.
Joe Heck
11:15 a.m.
New subject: RLV12 located with cable
I don't need an RL01/RL02 cable anymore but I could use the cables/
panels needed to connect an RQDX3 to an MFM hard drive.
Alternatively, a BA23 would be nice. Have one of those to sell?
Thanks!
David
On Dec 1, 2005, at 2:07 PM, Joe Heck wrote:
David Betz wrote:
I have a wire that is broken on the Berg
connector that plugs into
my DLV12 controller for my RL01 drive. How do I remove one of the
pins from the Berg connector so that I can reattach the broken
wire? Is it possible to repair these connectors or do I have to
replace it?
Sure enough, I finally found my RLV12 with the ribbon cable and
adapter. I noticed your email about getting it running already, so
does that mean you don't need a cable any more?
The RLV12 was at a customer site that I had already looked at, but
apparently not thoroughly enough.
Joe Heck
7625
days inactive
7639
days old
2 comments
2 participants
participants (2)
-
dbetz＠xlisper.mv.com -
Trash3＠splab.cas.neu.edu