From: Richard Erlacher <edick(a)idcomm.com>
I'd be VERY interested in seeing that schematic,
Tony! I've no doubt
that it
can be done, but I wonder how fast it will be.
The commercial ones are at least several mb/sec using drives designed for
DMA33. Only took a minute or less to transfer a set of 28 .CAB files
(w95).
The device driver runs as a SCSI device under W9x or NT4.
Allison
----- Original Message -----
From: "Tony Duell" <ard(a)p850ug1.demon.co.uk>
To: <classiccmp(a)classiccmp.org>
Sent: Wednesday, March 28, 2001 11:01 AM
Subject: Re: ide harddrive
> >
> > Evening folks, I am looking for a circuit using the parallel port on
a
> > pc to Ide interface, does anyone have a
schematic for one?
>
> Somewhere I have an data sheet for a chip to convert a parallel port
into
> an ISA slot. No, I don't mean a chip for
adding a printer port to the
ISA
> bus (like the 82C11 does), I mean a chip that
connects to a parallel
port
> (either 'original' or one of the enhanced
bidirectional ports), and to
> some DRAM, and which allows you to connect anything that you'd
normally
> connect to ISA on the other side of it. It allows
you to read/write
any
> port or memory location from the parallel port
side, it allows the ISA
> device to do DMA into the memory hung off the chip (which can then be
> read/written from the parellel port), and so on.
>
> I think it was made by SMC, but don't quote me on that.
>
> It looked like a fun device to work with, but I don't know where on
earth
> you'd find one.
>
> If anyone is interested, I will try and find the data sheet and post
the
number of the
device.
-tony