Yes, you can Charles. The RL11 controller is for the RL01 and the RL02, and the RL11 can be installed in any UNIBUS machine. (Ok, you must have a hex slot available). Look if you have XXDP for the 11/24 on your pack. As the CPU has 2 ports, I guess that one will be configured for the console (guessing, because I do not have a /24. Still missing that one in my UNIBUS-based collection). BTW, my RL02's (both) happily boot RT11, after I swapped the RL11 from the attick! I can even boot while the RL01 and both RL02's are in the chain, but I knew that you can mix these types of drives. However, the RL01 has a READY lamp that is always on, it does not interfere with the other drives ... I will be looking at some repair work in a few weeks or so. First, I want to get my RK07's also operational on the 11/34, and even before that, I will make a few copies of my dearly treasured RT11 and XXDP RL02 packs !! :-) - Henk, PA8PDP. ________________________________ Van: cctalk-bounces at classiccmp.org namens Charles Verzonden: za 07-01-2006 21:34 Aan: cctalk at classiccmp.org Onderwerp: New 11/24, what to do first? More info (cont'd) What I was wondering (when I mistakenly hit Send) was: ...since it has an RL controller card if I hooked up my RL02 with the XXDP pack, can it be run on this 11/24 system too? thanks Charles This message and attachment(s) are intended solely for the use of the addressee and may contain information that is privileged, confidential or otherwise exempt from disclosure under applicable law. If you are not the intended recipient or agent thereof responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately by telephone and with a "reply" message. Thank you for your cooperation.