23 Feb
2021
23 Feb
'21
1:45 p.m.
Message: 5
Date: Mon, 22 Feb 2021 21:45:24 -0600
From: Jon Elson <elson at pico-systems.com>
To: Brad H <unclefalter at yahoo.ca>, General at ezwind.net,
Discussion at ezwind.net:On-Topic and Off-Topic Posts
<cctalk at classiccmp.org>
Subject: Re: MSI 6800 EPROM Software
Message-ID: <60347A54.5070803 at pico-systems.com>
Content-Type: text/plain; charset=UTF-8; format=flowed
On 02/22/2021 01:31 PM, Brad H via cctalk wrote:
Reading them is pretty easy. BURNING them is crazy. They
need an 80 V power supply, and I think you XOR the address
or something as you apply the programming voltage.
Jon
Actually, programming a 1702 only requires a -48 volt pulse for each
address. Here's the datasheet:
https://www.jmargolin.com/patents/1702a.pdf
Hi there,
A longshot I'm sure - but I am wondering if anyone familiar with MSI
(Midwest
Scentific - SS50 bus system) would happen to have a copy of the
software for their 1702A EPROM burner, I think the model is PR-1. I just
picked one up and am eager to see if I can use it to read/burn 1702As,
something that has been an issue for me for a while now.
23 Feb
23 Feb
3:17 p.m.
On 2021-Feb-23, at 1:45 PM, Frank Tuccio via cctech wrote:
On 02/22/2021 01:31 PM, Brad H via cctalk wrote:
Reading them is pretty easy. BURNING them is crazy. They
need an 80 V power supply, and I think you XOR the address
or something as you apply the programming voltage.
Jon
Actually, programming a 1702 only requires a -48 volt pulse for each
address. Here's the datasheet:
https://www.jmargolin.com/patents/1702a.pdf
Ya, but that's with a Vbb of +12V, so the differential required from the power
supplies is 60V.
(Per the datasheet, it was ~ 55V in the 1702 programmer I once had.)
But that's the easy part.
And the semi-complex timing and switched-complementing of the address can be done in
software.
The hassle is that the data lines, address lines and several of the supply and control
lines all have to be switched independently with these high voltages. So it's a small
mess of specialised discrete drivers and hardware.
It's not just pulse a high voltage to one PGM pin like it was for 2716s and later
eproms.
I don't know what the 2708 (after the 1702, before the 2716) requirements were.
A longshot I'm sure - but I am wondering if anyone familiar with MSI
(Midwest
Scentific - SS50 bus system) would happen to have a copy of the
software for their 1702A EPROM burner, I think the model is PR-1. I just
picked one up and am eager to see if I can use it to read/burn 1702As,
something that has been an issue for me for a while now.
1837
days inactive
1837
days old
1 comments
2 participants
participants (2)
-
bhilpert＠shaw.ca -
frank＠tuccio.net