And the newer machine than the MIO's use EIO - such as the 4000 series and others. I have an unused II/III series XIO in a box around here, maybe I'll dig it out and post the HP type and part number. The customs for the P types are almost impossible to locate anymore since I think they weren't big sellers and cost too much so HP cut production on them. Of course ANY parallel type printer can use a generic print server, attached to the printer port, OR use an old 386 or 486 machine w/ network card as a print server to take the load off the other machines. -> -----Original Message----- -> From: owner-classiccmp(a)classiccmp.org -> [mailto:owner-classiccmp@classiccmp.org]On Behalf Of Geoff Reed -> Sent: Friday, July 06, 2001 3:05 AM -> To: classiccmp(a)classiccmp.org -> Subject: Re: Ancient LaserJet-3 question -> -> -> The lasterjet4 and newer use MIO cards, the LAsterjet 3 and 2 -> use XIO cards -> and the 2p / 3p use a custom backplate. -> -> Xio cards are between 2 and 3 inches wide and about 4 or 5 inches long. -> -> Mio cards are roughly 4x5 ish -> -> At 06:33 AM 7/6/01 +0000, you wrote: -> >On Jul 5, 19:20, Ethan Dicks wrote: -> > > -> > > --- Lawrence LeMay <lemay(a)cs.umn.edu> wrote: -> > > > I don't suppose it uses a MIO card? -> > > > -> > > > -Lawrence LeMay -> > > > -> > > > > Does anyone out there have a 10BaseT card they can't use -> > > -> > > How could I tell? The LJIII cards are the size of my hand with a -> >centered -> > > set of edge card fingers on on short end. They are 1/2 the -> size of LJ4 -> > > cards. -> > -> >I thought the cards were the same, but the LJ4 has an extra -> blanking plate? -> > -> >-- -> >Pete Peter Turnbull -> > Network Manager -> > University of York ->