PDP 11/23 Help - test-drb@ccmp.vtda.org

13 Dec 1999

...
 The "halt" switch is set. This causes the
system to pop into ODT rather
than to run programs. On the 11/23 there are _two_ halt switches, one on
the front of the box and one on the BDV11 boot/terminator board. I'm
guessing that you switched on, or the other, or both somehow. 
I would not suspect this since the system actually ran the ROM code
far enough to prompt 'Start?'...  If it were in the halt position,
you wouldn't even get this much...

					Megan Gentry
					Former RT-11 Developer

+--------------------------------+-------------------------------------+
| Megan Gentry, EMT/B, PP-ASEL   | Internet (work): gentry!zk3.dec.com |
| Unix Support Engineering Group |          (home):  mbg!world.std.com |
| Compaq Computer Corporation    | addresses need '@' in place of '!'  |
| 110 Spitbrook Rd. ZK03-2/T43   | URL:     http://world.std.com/~mbg/ | 
| Nashua, NH 03062               | "pdp-11 programmer - some assembler |
| (603) 884 1055                 |  required." - mbg                   |
--------------------------------+-------------------------------------+