Jay, There should be a setting in the scanning software which changes the settings for the scanner. What you are looking for is a 'descreen' setting to remove the moire from the scanned page. There are other settings for 'art print' and so on and you might want to experiment to see what looks best. I use Umax software and hardware but yours should be something the same. Good luck! Jay West wrote: -- http://www.geocities.com/SiliconValley/Horizon/9107/

Jay West wrote: It sounds like the software that you are using to display the scanned images is seriously deficient. The scanned image is apparently OK. There are several ways to scale down the image for display. They range horrible picture, to taking a lot of computation but looking beautiful. The simplest approach is that if you want to display a 1/4 scale image, you throw away 3 out of every 4 pixels, both vertically and horizontally, for a total of 15 of every 16. This approach yields very poor results, but some programs that are designed to deal with photographic images actually do this, because even though it is not that good for photographs either, it is not as bad as with text and line art. This approach is even worse if you don't want to do scaling by an integral amount. For instance, if the program decides that it needs to display every 3.5th pixel, it will skip 2, display 1, skip 3, display 1, etc. This yields even worse aliasing than skipping a constant number of pixels. There are two approaches that yield much better results. One is the use of greyscale. In the 1/4 scale example, instead of throwing away 15 pixels out of 16, you count the number of pixels that were black. Let's say there are 6. You make the resulting pixel 6/16 black. This is not too computationally intensive, but it can have some of the same problems if you use non-integral scale factors. The "correct" approach is to run the image through a low-pass filter before scaling it down. This is much more computationally intensive than the other approaches, but it yields excellent results in grey scale, and quite good results in bilevel, even for non-integral scale factors. I normally use the "xv" program under Linux to view images, and it appears to use the filtering approach. On my Pentium Pro 150, it takes about six seconds for it to filter the page. I think the code in xv is not very highly optimized (and I'm not talking about the compiler), because I've seen other applications that do the same thing but don't take nearly as long. For instance, Acrobat Reader on the same machine takes only about two seconds. Cheers, Eric

At 02:09 PM 2/7/99 -0600, you wrote: scan settings are Line Art at 300dpi. Screens are apx. 72 dots per inch. When the browser tries to interpolate your 300dpi scans, it all goes to heck! (ruled by that guy with the spoon If you want something that will display half way decent in a browser, you will need to rescan them at around 72dpi. -jim --- jimw(a)agora.rdrop.com The Computer Garage - http://www.rdrop.com/~jimw Computer Garage Fax - (503) 646-0174