Veroboard trace cutting tool? - test-drb@ccmp.vtda.org

4 Dec 2004

On Dec 5 2004, 13:31, Bert Thomas wrote:
...
  > However, if I want it to look neater (I meant to
mention this in my
 > previous message) -- though goodness knows who would care -- I have
 > been known to use a scalpel or craft knife to cut the copper either
 > side of a hole and then lift off the small redundant piece.  I've also
...
  > done that between holes, when I wanted to use two
adjacent holes but
...
   isolated from
each other. 
 Aaarggghhh, <undo><undo><undo><undo><undo>... ;-) 
Why "undo"?  Great minds obviously think alike, and two posts just
reinforce the value of the advice :-)

-- 
Pete						Peter Turnbull
						Network Manager
						University of York