Hi all, I'm hoping to get an answer here. The 8625 barcode printer has a prompting mode, switched on by activating the bottom switch in a bank of switches. The printer is then supposed to write a prompt, so you can start programming the label formats. I seem to remember that the printer expects a CTRL+H sequence to be reset/restarted, but nothing happens. Can any of you remember the settings for the terminal (I do know about 9600,7,1,even) ? I'm not sure on which terminal the printer expects to write to. VT100 ? ANSI? ? And how about flow control? Any help would be appreciated Regards Nico PS The printer is to be used for museum purposes, and as usual, the museum has no money to spend :-(