8 Mar
2002
8 Mar
'02
2:45 a.m.
Hi,
would somebody here be so kind an give me a digital image of a
KDA50 cab kit? A part number would also be nice, but the picture
would be better. Doesn't need to be very good quality, just to
roughly see how it looks.
Thanks,
-Gunther
PS: even a detailled description would be helpful. Thanks!!
8 Mar
8 Mar
3:11 a.m.
Gunther Schadow wrote:
Hi,
would somebody here be so kind an give me a digital image of a
KDA50 cab kit? A part number would also be nice, but the picture
would be better. Doesn't need to be very good quality, just to
roughly see how it looks.
Thanks,
-Gunther
PS: even a detailled description would be helpful. Thanks!!
You didn't specify which cabinet you have. I may have a picture of
the BA213 kit I sold last year. I'll can check after work, if this
is the one you need.
-nick
3:45 p.m.
Nick,
You didn't specify which cabinet you have. I may
have a picture of
the BA213 kit I sold last year. I'll can check after work, if this
is the one you need.
I guess so. I personally have a uVAX-II in the small cabinet, but
I take anything, I don't care about the larger metal pieces, what
I care about is the cable to the card and the SDI connectors. Those
should be the same. I need the picture so a guy who doesn't know
these things but may have the cables in a pile of stuff can recognize
it.
Thanks!
-Gunther
--
Gunther Schadow, M.D., Ph.D. gschadow(a)regenstrief.org
Medical Information Scientist Regenstrief Institute for Health Care
Adjunct Assistant Professor Indiana University School of Medicine
tel:1(317)630-7960 http://aurora.regenstrief.org
12 Mar
12 Mar
5:24 a.m.
Gunther Schadow wrote:
I guess so. I personally have a uVAX-II in the small
cabinet, but
I take anything, I don't care about the larger metal pieces, what
I care about is the cable to the card and the SDI connectors. Those
should be the same. I need the picture so a guy who doesn't know
these things but may have the cables in a pile of stuff can recognize
it.
I have the cable kit for the BA200 series cabinets as well. You are
right, it will work in a BA123 if you just route the pigtails out a hole
in the rear bulkhead. The part number for the one I have is
17-00951-03. It has a 32 pin Berg connector on the module end with a
funny flat plastic retainer that holds it in. The pigtails are about 30
inches long and each has the metal 8 pin connector that mates to the
disk drive cables.
I'll send pictures in a separate message to you directly.
--
Doug Carman
pdp11 at bellsouth dot net
8169
days inactive
8173
days old
3 comments
4 participants
participants (4)
-
gunther＠aurora.regenstrief.org -
oliv555＠arrl.net -
pdp11＠bellsouth.net -
schadow＠aurora.regenstrief.org