Hello to all, I'm still looking for information for these items: Firstly, an Infotron IF/65 Development System II. It appears to connect via RS-232 to a dumb terminal for its output of such things as address and data, and perhaps input of some parameters such as uP clock rate; baud rate is selectable from a thumbwheel. This system also appears to have the capability of single stepping the program contained in the device in the ZIF. It has a 28 pin ZIF socket for the targets EPROM/PROM/ROM. There is a standard ribbon cable that connects to a pod, and the pod has a braided ribbon cable that terminates at a 40 pin dip header, most likely to attach to the target in place of the uP. Trap conditions are selectable via four 0 to F thumbwheels, and conditions to be triggered on can be selected as memory data read, memory data written, and/or op-code. Any information would be greatly appreciated, a source of a manual or instructions for use would be fantastic. This equipment can be viewed at http://www.wpic.com/whdawson/Pics/infotron.gif and secondly: A CUBIT EPROM programming board for the AIM-65. It is not an RM65 board, the connector will plug right onto the expansion connector on an AIM, but can also be attached with an appropriate 1-to-1 ribbon cable. Here is the description: Measures 4-7/16 (4.4375)inches wide by 6-1/2 (6.5) inches long, including edge connector, lengthwise insertion. 44 pin gold plated edge connector with a 44 pin socket mounted immediately behind and parallel to the edge connector, on the component side of the PCB. 24 pin ZIF connector in the upper LH corner, viewing with the edge connector facing me (all descriptions below assume this position). 10 position DIP switch immediately to the right of the ZIF socket (no labeling), and another 10 position dip switch about halfway up the RHS, labeled 1 to 7 and B, C, D (probably address selection since one row of pins is all tied common and most of the pins on the other side of it go to a 74LS154). One LED, immediately to the right of the first 10 position DIP switch mentioned above, at the edge of the board. Two trimpots about center of the far edge of the board, to the right of the LED. Two jumper blocks, one with 2 pins, labeled W1, and one with 3 pins, labeled RO and RA. Two Toshiba 24 pin TMM2016P-1 RAMs left of center in second row of DIPs on the board. One 2516-45 EPROM to the left of the RAMS, with a label on top "6517A". On the solder side the only markings (in etch) are CUBIT INC, 1981 and the numbers 10362 and 6583. Most of the date codes on the ICs are between 8037 and 8203. There is no other model number, manufacturer, or other ID marking on this board. This programmer can be viewed at http://www.wpic.com/whdawson/Pics/cubit.jpg Thanks, Bill whdawson(a)mlynk.com