27 Jan
2003
27 Jan
'03
12:41 p.m.
Omnibus or Posibus? Why not Negibus? Neither Omnibus nor Posibus would help
me on my 8/i, since mine is Negibus... An SSD would be a Very Cool Thing to
have though... Especially since it really wouldn't have to be very large in
terms of capacity..
Will J
_________________________________________________________________
Tired of spam? Get advanced junk mail protection with MSN 8.
http://join.msn.com/?page=features/junkmail
27 Jan
27 Jan
1:05 p.m.
Will J wrote:
Omnibus or Posibus? Why not Negibus? Neither Omnibus
nor Posibus would
help me on my 8/i, since mine is Negibus...
One problem with building either posibus or negibus devices is that
DEC connector blocks seem to be made of unobtanium these days. At
one time there were some made by other vendors, which were generally
inferior to the DEC ones, but it doesn't appear that any are available
now.
Building an Omnibus card doesn't require any DEC connector blocks,
making it somewhat easier.
It would be nice to find a source of the DEC plastic module handles,
and the metal stiffener/ejector handles used on DEC hex-height modules.
But I'm not holding my breath for those, either.
31 Jan
31 Jan
11:42 p.m.
I beleive that Al got a few (one or two?) Augat wire-wrap quad DEC
modules along with the CADR
hardware. There was at least one quad unibus Chaos net interface board.
This board may be slightly
interesting historically, but its unstuffed and I don't beleive that any
drivers existed for it.
To the best of my knowledge, it was an abandoned incomplete hack.
You might want to unwrap the board, then use it for a PDP-8 project.
I'd guess that using the Dallas NVRAM (really excellent products by the
way) to emulate a PDP-8 disk
would be much simpler than my IDE hack. A simple 20 Mhz PIC would
probably be more than sufficient.
But I have no idea of what an omnibus interface looks like electrically.
Is this a painful thing to build?
Eric Smith wrote:
Will J wrote:
Omnibus or Posibus? Why not Negibus? Neither
Omnibus nor Posibus would
help me on my 8/i, since mine is Negibus...
One problem with building either posibus or negibus devices is that
DEC connector blocks seem to be made of unobtanium these days. At
one time there were some made by other vendors, which were generally
inferior to the DEC ones, but it doesn't appear that any are available
now.
Building an Omnibus card doesn't require any DEC connector blocks,
making it somewhat easier.
It would be nice to find a source of the DEC plastic module handles,
and the metal stiffener/ejector handles used on DEC hex-height modules.
But I'm not holding my breath for those, either.
7995
days inactive
8000
days old
2 comments
3 participants
participants (3)
-
bshannon＠tiac.net -
eric＠brouhaha.com -
xds_sigma7＠hotmail.com