Frank, I very much appreciate the response - however, *I* am Sharkonwheels on VC! :) I've never run into a HandyMan, though... 'ppreciate the confidence, though! Tony -----Original Message----- From: FJGJR1 at aol.com Sent 8/31/2008 2:23:27 PM To: cctalk at classiccmp.org Subject: MY REPLY - Re: HandyMan for Kaypro Tony, You want to check with "Sharkonwheels" who posts on _www.vintage-computer.com_ (http://www.vintage-computer.com) . He is very knowledgeable on Kaypros "after" 1983. He uses and has info on Advent products. I am more involved with the 1982 / 1983 versions and post under GADFRAN. My website _www.kayprosts.org_ (http://www.kayprosts.org) may give you some other productive contacts to explore. He may also know of HandyMan. You may want to check just what version of K4 you have. Main large chips on main board will help - e.g. U43 and U47, etc. He will be asking you about them and other aspects. He is very familiar with the K10's. Hope this helps some. Frank In a message dated 8/31/2008 2:08:07 A.M. Eastern Daylight Time, tonym at compusource.net writes: I asked a while back on comp.os.cpm, and didn't get much response... Anyone remember how to use a HandyMan for the kaypro? This was an add-in board, piggy-backed between the Z80 and socket, and had a TSR-like pop-up Borland SideKick wanna-be. Trying to find some info, as a K10 I acquired came with a handyMan, and Advent 1MB RAMDisk, and K4 came with an Advent Clock, RamDisk, ProGraphics board, Personality module, and 5mHz turboboard. Tony **************It's only a deal if it's where you want to go. Find your travel deal here. (http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)