I got ahead of myself a little bit... forgot I still couldn't connect a
serial port to SIMH.
Turns out my version of SIMH 3.08 was from 2008 or so... I just downloaded
the latest version 4 from GitHub and sure enough it does accept SET CONSOLE
SERIAL.
Now I just have to figure out the port name since it doesn't like COM4:
But I'm almost there :)
-----Original Message-----
From: Charles
Sent: Friday, September 13, 2019 6:46 PM
To: J. David Bryan ; cctalk digest
Subject: Re: Connecting SIMH to teletype via USB
Update: got my SIMH (set console telnet:23) talking to PuTTY in another
window, via Telnet 127.0.0.1:23.
So it is possible ;)
Now it's time to hook up the actual TTY to the USB-current loop card and see
what's what!
-----Original Message-----
From: J. David Bryan
Sent: Friday, September 13, 2019 6:23 PM
To: General Discussion: On-Topic and Off-Topic Posts
Cc: Charles
Subject: Re: Connecting SIMH to teletype via USB
On Friday, September 13, 2019 at 15:42, Charles via cctalk wrote:
I could use a hint... I have a USB to current-loop
(Volpe) interface
board, and Windows 7 on my laptop does recognize it as COM4 at 110
baud. So far so good. No problem hooking it up to my ASR-33 Teletype.
Now I'd really like to figure out how to set SIMH to use the 33 as the
console, so the TTY will be attached to the virtual PDP-8.
Section 3.14, "Console Options" of the "SIMH Users' Guide V4.0"
suggests
that:
set console serial=com4;110-8n2
...should work (though you might need "7e2" or "7o2" instead,
depending on
how your Teletype is set up).
Anything that starts with "set console..."
gives a "no settable
parameters" error.
Does the above also give this error?
-- Dave
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus