what bus is this for? - test-drb@ccmp.vtda.org

3 Feb 2006

Date: Fri, 03 Feb 2006 15:52:22 -0800
From: "Chuck Guzis" <cclist at sydex.com>
Subject: Re: what bus is this for?

On 2/3/2006 at 3:30 PM Dwight Elvey wrote:

...
 >Hi
> I think ( but I'm not sure ) that this spacing was
>used for the bus connectors on the KIM-1 and the SYM-1/2.
>Dwight 
...
 Could be.  I've got an Optimal Technology EP-2A
EPROM programmer board that
I believe was intended for use with the KIM-1. It does use that 44-pin
connector. 
<snip>

Also used on the AIM65 (and, IIRC, the VIC20)

BTW, Issue 7 of the AIM Interactive mag (available on Rich's site) had the 
schematic & software (in Forth) for a very simple 2716/2532(2732) EPROM 
programmer; 2 TTL & CMOS chips and two relays (!).

mike