I decided just to fire it up and see if anything blew... it issued the expected beep as it came up. Set the switch to half-duplex and it does actually echo bell (Ctrl-G) and I can see the screen moving as I type! But there is some kind of garbage every other row, although the cursor moves and the screen will "clear" (except for the 12 rows of garbage). Power supply is 5.11 volts. So far so good. Unfortunately the screen rot is even worse than I thought - the PVA layer is so opaque and bubbled it looked like cottage cheese once removed, and I can't make out what characters are on the CRT... I took the monitor out (very easy disassembly). I didn't even have to use a heat gun or a hot wire, just started at one corner, applied a steady and gentle pull, and it came off in one sheet with a giant sucking sound. That oily mess took a while to clean up. I also scrubbed off the black anti-reflective coating since it was significantly scratched and peeled anyway. Now waiting for the bead of clear silicone (around the outside of the plate only) to cure. I'll make sure it's air tight so no black dust will get in there by electrostatic attraction. I can fix the RAM problem once I can see what is actually on the screen! ;) Also the wire bracket with threaded ends that holds the flyback to the monitor chassis is missing one end entirely, so I need to fix that (keep the core halves firmly together). Looks like I didn't get TOO bad a deal for $200 shipped, especially with upper-case installed. --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus