IMSAI MIO REV.2 - test-drb@ccmp.vtda.org

19 Jul 1999

have you emailed Todd Fisher of www.imsai.net fame?  I asked him for
connector pinouts for the PIO4 and PIO6 boards and he did, after some time
searching for and preparing the documents, post them on his web site.  I've
already checked and the MIO is not supported yet.  Perhaps a little jarring
...
 from you would motivate him. 
He's probably busy, though, as he was planning to release his new computer
in the old box, or whatever he was planning  . . .  by mid-summer (that's
now!)

Dick

-----Original Message-----
From: Bill Sudbrink &lt;bill(a)chipware.com&gt;
To: Discussion re-collecting of classic computers
&lt;classiccmp(a)u.washington.edu&gt;
Date: Monday, July 19, 1999 5:02 PM
Subject: RE: IMSAI MIO REV.2

...
   jumpers and
two sets of DIP switches.  Could
 some kind soul email me the config info (at
 least for the serial port) on this thing? 
And the pin-outs for the edge connectors
would help too.

Thanks,
Bill Sudbrink