21 Sep
2015
21 Sep
'15
1:51 p.m.
I was wondering if anyone has or knows anyone who has experience with
low volume sheet metal enclosure fabrication? I am looking for a
fabricator to build small (think game cartridge enclosure sizes)
clamshell units (or similar).
I thought before I start cold calling folks, I'd see if someone has
already had some success.
--
Jim Brain
brain at jbrain.com
www.jbrain.com
21 Sep
21 Sep
1:54 p.m.
There are a lot of folks in VMS on the metal fabrication and I just happen to know someone
that has opened a small volume fabrication company on Cape Cod. Do I have your ok to
forward?
Sue
On Sep 21, 2015, at 1:51 PM, Jim Brain <brain at
jbrain.com> wrote:
I was wondering if anyone has or knows anyone who has experience with low volume sheet
metal enclosure fabrication? I am looking for a fabricator to build small (think game
cartridge enclosure sizes) clamshell units (or similar).
I thought before I start cold calling folks, I'd see if someone has already had some
success.
--
Jim Brain
brain at jbrain.com
www.jbrain.com
Sue Skonetski
VP of Customer Advocacy
Sue.Skonetski at vmssoftware.com
Office: +1 (978) 451-0116
Mobile: +1 (603) 494-9886
Mit freundlichen Gr??en ? Avec mes meilleures salutations
2:28 p.m.
I have a somewhat similar question....
A couple items in my holdings have rust, typically on large sheet metal outer enclosures.
A prime example is the pedestal for my DG TP1 printing terminal. The only good solution I
could see is having the existing metalwork sandblasted and then repainted. I've not
checked, but I suspect that's "non-trivial-$".
Thoughts?
J
3227
days inactive
3227
days old
3 comments
3 participants
participants (3)
-
brain＠jbrain.com -
jwest＠classiccmp.org -
Sue.Skonetski＠VMSSoftware.com