7 Mar
2003
7 Mar
'03
3:49 a.m.
I'd like to know the pinouts for the power connector (6 pins) and or battery
pack (4 contacts) for the Compaq SLT286. I have a battery pack, but it is
dead and too well sealed for me to want to open it up.
Bob
7 Mar
7 Mar
9:07 a.m.
--- "Feldman, Robert" <Robert_Feldman(a)jdedwards.com> wrote:
I'd like to know the pinouts for the power
connector (6 pins) and or
battery
pack (4 contacts) for the Compaq SLT286. I have a battery pack, but it is
dead and too well sealed for me to want to open it up.
Please post publicly (or send me a copy). I have an SLT286, no battery,
no brick, but at least it has a docking station. It's where my device
programmer ended up. After performing surgery on my Dallas module, I
found a spare one on a dead PeeCee mobo that I transplanted and I'm
back business, but because I put low-profile socket pins in the SLT
motherboard, there wasn't enough clearance to put the aluminim skins back
on - I decided to cut a small hole in the bottom of the battery
compartment - the Dallas module now sticks up about .5 mm. :-(
On the bright side, the battery compartment gave me a place to rest my
CR2032 that I attached to the internal leads of the old Dallas module
before I found a replacement. :-)
-ethan
10:22 a.m.
On Fri, 7 Mar 2003, Ethan Dicks wrote:
--- "Feldman, Robert"
<Robert_Feldman(a)jdedwards.com> wrote:
> I'd like to know the pinouts for the power connector (6 pins) and or
> battery
> pack (4 contacts) for the Compaq SLT286. I have a battery pack, but it is
> dead and too well sealed for me to want to open it up.
-ethan
Please post publicly (or send me a copy). I have an SLT286, no battery,
no brick, but at least it has a docking station. It's where my device
I'm not entirely sure if I've done this right (Gee, there's confidence for
you), but:
The battery, when looking at it towards the connectors:
----------------------
| XXXX |
|______________________|
Where X's are contacts, from left to right:
GND, 12.5v, 12.5v, 13.3v
(Batt is Compaq part #130538, Model 2682)
I don't know enough about electronics to understand how the power supply
works. The unit has two lights, which I'm guessing are 'On' and 'Charging
Battery'. When the unit is first turned on, the 'On' pulses.
There are Eight pins, not 6: (Piss poor ASCII arrangement on left, my pin
numbering on right)
X X X 1 2 3
X X X 4 5 6
_ _ 7 8
If you cross 3 & 6, the 'On' light stays on, presumably the trigger to
tell it to send voltage.
With one probe between the 3&6, and another on 4, I get 18vDC.
Unfortunately my limited understanding of how this kind of thing works is
as far as I can determine.
My apologies. Better than nothing at all, I hope.
If you can explain what else to look for, I have a multimeter and am
willing to fiddle.
I have a complete SLT286 with its little carry bag and even the numeric
keypad clip-on. No docking station though.
JP Hindin
7803
days inactive
7803
days old
2 comments
3 participants
participants (3)
-
erd_6502＠yahoo.com -
jplist＠kiwigeek.com -
Robert_Feldman＠jdedwards.com