27 Jul
2012
27 Jul
'12
7:09 a.m.
Is there any reason to use either a CMOS or TTL Crystal Oscillator for a
Cosmac computer? I assume it should accept either, any preference if
you had a choice? Thanks, and can't wait to showcase some of the DIY
computers I am working on at this years VCFMW!
27 Jul
27 Jul
5:05 p.m.
On 07/27/2012 10:09 AM, Nick Allen wrote:
Is there any reason to use either a CMOS or TTL
Crystal Oscillator for
a Cosmac computer? I assume it should accept either, any preference
if you had a choice? Thanks, and can't wait to showcase some of the
DIY computers I am working on at this years VCFMW!
No reason at all, however do connect it to the right pins and insure the
frequency
is not too high as the cosmac is a fairly slow chip.
I've done it many times and the Spare Time Gizmos ELF2000 design does it
as well.
Allison
10:59 p.m.
Nick Allen wrote:
Is there any reason to use either a CMOS or TTL
Crystal Oscillator for
a Cosmac computer? I assume it should accept either, any preference
if you had a choice?
There's no reason to use either. Just use a crystal. I don't remember
ever seeing an 1802 system with a separate oscillator, though it's
certainly possible to do it.
If you feel that you *must* use a separate oscillator, and you're
running the 1802 at 5.0V, then you should use a 5V CMOS oscillator,
because the Vih spec is 3.5V min, and TTL outputs don't typically go
that high. You might be able to get away with a TTL oscillator with a
pullup resistor.
4843
days inactive
4844
days old
2 comments
3 participants
participants (3)
-
ajp166＠verizon.net -
eric＠brouhaha.com -
nick.allen＠comcast.net