Hi Guys Well the original panel arrived yesterday and revealed one or two interesting features. It was from an 8/m but as the underlying programmers console (apart from the change from bulb to LED) is the same for all of versions I am making. Its a good example What it reveals was that they silk screened the panel first then routed or milled out the openings using the markings as a guide. This is the source of much complained of chipping and peeling. This means that they did not have to be too fussy with the placement of the silk screening in relation to the edges of the blank. Any small offset would be hidden by the bezel anyway. in addition there is plenty of tolerance on the key lock - there's provision to adjust its position on the mounting. The hole for the select switch is drilled over size (0.38" for a 0.25" shaft) so more room to move things about In the spirit of "measure twice and cut once" would all those with orders please do the following. Take off the selector switch knob. Remove the bezel and take the old front panel out. Measure from the bottom edge of the panel to the bottom of the row of switch openings. Then from the left hand side to the first switch opening. Finally from the right hand side to the last switch opening. Please send the three measurements with the type of system its off plus any part numbers on the back of the panel to me. Regards Rod