14 Sep
2007
14 Sep
'07
10:27 a.m.
On 14 Sep 2007 at 9:41, Chuck Guzis wrote:
I'd appreciate it, Glen. Only the handshaking
lines (IFBY, IDBY)
need be buzzed out, I think. The tape motion commands seem to work
just fine, but reading or writing moves the tape without the driver
returning (i.e. stays busy). I built my cable from an Overland
description, so I'm not completely sure that it's correct.
I buzzed out my Overland cable some time ago, and just checked the
handshake lines above against the reference you used. They match.
For reference, my cable wiring is at:
http://www.kallisti.com/~allanh/misc/overlandperteccable.html
allan
--
Allan N. Hessenflow allanh at kallisti.com
15 Sep
15 Sep
12:47 p.m.
On 14 Sep 2007 at 10:27, Allan Hessenflow wrote:
I buzzed out my Overland cable some time ago, and just
checked the
handshake lines above against the reference you used. They match.
For reference, my cable wiring is at:
http://www.kallisti.com/~allanh/misc/overlandperteccable.html
Thanks, Allan. My point of curiosity was if the Overland cable was
the same as that used for the Computer Logics PCTD16 controller. I
suspect so, but I'm not certain.
-Chuck
6260
days inactive
6261
days old
1 comments
2 participants
participants (2)
-
allanh-cctalk2＠kallisti.com -
cclist＠sydex.com