20 Feb
2001
20 Feb
'01
2:26 a.m.
Well the RD52 in my 11/83 died, only the second failure for this box
in over 12 years. Tried to use the UC07 board (out of a mVax) to instal
a SCSI drive but can't get the 11/83 to recognize it, let alone format.
Anyone had success in using this board with the PDP11? I've set the
address to 172154 as the M7555 is still onboard to allow the rx33 as
the boot device. Will the DEC diags format the SCSI (i expect not)?
Thanks ........ nick o
20 Feb
20 Feb
3:10 a.m.
At 10:26 AM 2/20/01 -0600, you wrote:
Anyone had success in using this board with the PDP11?
I've set the
address to 172154 as the M7555 is still onboard to allow the rx33 as
the boot device. Will the DEC diags format the SCSI (i expect not)?
Did you mean you set it for 760330 rather than 172154? You want to set it
as the second MSCP disk controller since the M7555 is still there. It will
be 'dubx' in VAX parlance, not sure what it would show up as on the '11.
Also you probably have to sysgen the system to know about it.
--Chuck
9:50 a.m.
Chuck McManis wrote:
At 10:26 AM 2/20/01 -0600, you wrote:
I'll try some other addresses tonight; under rt11 it should just appear
in the device list using *SHO ALL*. Never had it operational in my mVax
so there is the possibility i've a bad board.
thanks, nick
Anyone had success in using this board with the
PDP11? I've set the
address to 172154 as the M7555 is still onboard to allow the rx33 as
the boot device. Will the DEC diags format the SCSI (i expect not)?
Did you mean you set it for 760330 rather than 172154? You want to set it
as the second MSCP disk controller since the M7555 is still there. It will
be 'dubx' in VAX parlance, not sure what it would show up as on the '11.
Also you probably have to sysgen the system to know about it.
--Chuck
8706
days inactive
8706
days old
2 comments
2 participants
participants (2)
-
cmcmanis＠mcmanis.com -
oliv555＠arrl.net