18 Feb
2019
18 Feb
'19
10:37 a.m.
On Feb 18, 2019, at 11:00 AM, dwight wrote:
There were a couple hp XY plotters that had the mylar plate delaminating. I've
reworked these with model airplane mono coat.
Are you referring to MonoKote (www.monokote.com <http://www.monokote.com/>)? That
looks perfect for repairing the gouged bed of one of my 9872C plotters. Is a hot air
supply suitable for applying the film, or did you use their heating iron? I'm
guessing a bit of pressure to adhere the film is necessary?
18 Feb
18 Feb
2:15 p.m.
Also very interested in the use of Monokote to repair plotter beds...any more
info/experience/tips/traps would be much appreciated.
David Collins
HP Computer Museum
On 19 Feb 2019, at 5:37 am, Craig Ruff via cctech
<cctech at classiccmp.org> wrote:
On Feb 18, 2019, at 11:00 AM, dwight wrote:
There were a couple hp XY plotters that had the mylar plate delaminating. I've
reworked these with model airplane mono coat.
Are you referring to MonoKote (www.monokote.com <http://www.monokote.com/>)? That
looks perfect for repairing the gouged bed of one of my 9872C plotters. Is a hot air
supply suitable for applying the film, or did you use their heating iron? I'm
guessing a bit of pressure to adhere the film is necessary? 
8 p.m.
I find that it is too much pre-stretched I carefully remove some of the stretch with a
heat gun and a frame to hold it. You'd need to experiment some. It has to have a
little stretch left to shrink.
Dwight
________________________________
From: cctech <cctech-bounces at classiccmp.org> on behalf of David Collins via
cctech <cctech at classiccmp.org>
Sent: Monday, February 18, 2019 2:15 PM
To: Craig Ruff; General Discussion: On-Topic Posts
Subject: Re: Q: Plotter bed repair with MonoKote?
Also very interested in the use of Monokote to repair plotter beds...any more
info/experience/tips/traps would be much appreciated.
David Collins
HP Computer Museum
On 19 Feb 2019, at 5:37 am, Craig Ruff via cctech
<cctech at classiccmp.org> wrote:
On Feb 18, 2019, at 11:00 AM, dwight wrote:
There were a couple hp XY plotters that had the mylar plate delaminating. I've
reworked these with model airplane mono coat.
Are you referring to MonoKote (<http://>www.monokote.com
<http://www.monokote.com/>)? That looks perfect for repairing the gouged bed of one
of my 9872C plotters. Is a hot air supply suitable for applying the film, or did you use
their heating iron? I'm guessing a bit of pressure to adhere the film is necessary?
2041
days inactive
2042
days old
2 comments
3 participants
participants (3)
-
cruff＠ruffspot.net -
davidkcollins2＠gmail.com -
dkelvey＠hotmail.com