Tom Owad wrote:
I purchased a Tandy 600 at the York Hamfest on Sunday. The unit doesn't
seem to work - the screen fills up with garbage (just alternating pixels,
about 75% black). Anybody know what could cause this?
I had a similar problem with one someone had brought me to see if I could
get it working. It ended up working, but (and I *hate* this) the reason why
was and is unclear. What I did was to diassemble it and check out the
backup battery and the power to the board: both were okay. The thing that
finally got it working was when I removed the keyboard connector (probably
under power) and put it back. I don't remember the thought processes (no
comments please!) that caused be to try it. It happened again when the
backup battery went dead and again, I was able to bring it back to life. I
might add that I did have the power supply connected and plugged in when I
did this.
I'm trying to take the unit apart so I can look at
it, but its not
opening up very easily. Are there screws under the four rubber feet on
the bottom? They're in so good I'd have to tear them apart to get them
out, which I hate to do unless I know there are actually screws under it.
IIRC, the case has some tabs that hold it together, and after removing the
obvious screws, the thing can be gotten apart with some gentle prying. Good
luck.