21 Jan
2006
21 Jan
'06
4:48 p.m.
All:
I'm making that front panel power switch mod and I have a small
9v wall wart that I pulled apart, and a 9v relay. I want to encapsulate the
whole thing in a box. I don't know much about potting compounds - what would
be the best compound for this application?
Rich
Rich Cini
Collector of classic computers
Build Master for the Altair32 Emulation Project
Web site: <http://highgate.comm.sfu.ca/~rcini/classiccmp/>
http://highgate.comm.sfu.ca/~rcini/classiccmp/
/************************************************************/
21 Jan
21 Jan
6:03 p.m.
On 1/21/2006 at 7:48 PM Richard A. Cini wrote:
I'm making that front panel power
switch mod and I have a
small
9v wall wart that I pulled apart, and a 9v relay. I
want to encapsulate
the
whole thing in a box. I don't know much about
potting compounds - what
would be the best compound for this application?
I'd use a 2 part either acrylic or epoxy resin (with filler, if desired.
But why bother? Why not just a little die-cast utilty box?
22 Jan
22 Jan
10:42 a.m.
All:
I'm making that front panel power switch mod and I have a small
9v wall wart that I pulled apart, and a 9v relay. I want to encapsulate the
whole thing in a box. I don't know much about potting compounds - what would
be the best compound for this application?
I wouldn't do that. Why make it impossible to repair later? Personally,
I'd take a matal box, screw the transformer and relay to the inside, use
tagstrip or striboard to mount the smaller components. Connect the box to
mains earth and run the cables through grommets in the sides.
Then, if something fails later, it'll be easy to put right.
-tony
23 Jan
23 Jan
1:45 a.m.
I agree with Tony, don't pot the thing. Potting comound not only makes
it difficult or impossible to repair but it also severly limits the heat
dissappation of the electrical components and that will cause failures.
At 06:42 PM 1/22/06 +0000, you wrote:
>
> All:
>
>
>
> I'm making that front panel power switch mod and I have a small
> 9v wall wart that I pulled apart, and a 9v relay. I want to encapsulate the
> whole thing in a box. I don't know much about potting compounds - what
would
be the best
compound for this application?
I wouldn't do that. Why make it impossible to repair later? Personally,
I'd take a matal box, screw the transformer and relay to the inside, use
tagstrip or striboard to mount the smaller components. Connect the box to
mains earth and run the cables through grommets in the sides.
Then, if something fails later, it'll be easy to put right.
-tony
6860
days inactive
6861
days old
3 comments
4 participants
participants (4)
-
ard＠p850ug1.demon.co.uk -
cclist＠sydex.com -
rcini＠optonline.net -
rigdonj＠cfl.rr.com