8 Jan
2002
8 Jan
'02
12:39 a.m.
-----Original Message-----
From: Tothwolf [mailto:tothwolf@concentric.net]
Sent: 08 January 2002 12:23
To: classiccmp(a)classiccmp.org
Subject: Re: Back to board washing for a moment
Make sure you properly discharge the CRT and other caps in
the HV section
before disconnecting the anode lead from the CRT. You can
find some basic
service and safety information on the sci.electronics.repair
FAQ located
here: http://www.repairfaq.org/
Thanks for that; the board's been out of the chassis for over a week now;
I've just been trying to find time to clean it up.
If the flyback is suffering from bad soldering could that itself cause
stress in other components and thus the smoke? It won't take long to
resolder everything since it's not a very big board.....
cheers
--
Adrian Graham, Corporate Microsystems Ltd
e: adrian.graham(a)corporatemicrosystems.com
w: www.corporatemicrosystems.com
w2: www.binarydinosaurs.co.uk (Online Computer Museum)