26 Oct
2015
26 Oct
'15
12:58 a.m.
The socket is a metal piece with an inside thread on one end and an outside thread on the
other end. You commonly see them on serial connectors usually on the equipment the cable
attached too.
The bottoming out I was refering too was it you use a standoff you may have too much
exposed thread on the screws. They will meet inside the standoff before the connectors are
properly seated.
Joe
On Oct 25, 2015, at 5:28 PM, Eric Christopherson
<echristopherson at gmail.com> wrote:
On Sun, Oct 25, 2015 at 6:07 AM, Joseph Lang <joe.lang.0000 at gmail.com>
wrote:
4-40 is the correct size. I would remove the jack
screws on one side and
replace with sockets. If you use standoffs the screws May bottom out too
soon.
Could you explain that in more detail? I'm not aware of "sockets" except
as
the tools that are used for turning hex nuts; is there a kind of socket
that actually gets installed on a bolt?
And I'm not sure what you mean about bottoming out. You just mean there
wouldn't be enough length of thread to fit both male ends securely?
Joe
--
Eric Christopherson On Oct 24, 2015, at 5:47 PM, Eric Christopherson
<
echristopherson at gmail.com> wrote:
I have a Sun machine with a 13W3 framebuffer output, which is connected
via a Monoprice VGA adapter to my LCD monitor. It works great, but the
ends of the standoff bolts without nuts come together where the VGA
cable meets the adapter; that is to say, the VGA cable's nuts are on the
far side of the shell from its male end, and the adapter's nuts are on
the far side of the shell from its female end.
I'm wondering what I can put between the two to keep the cable from
disconnecting from the adapter. Some searches seem to indicate I want
some 4x40 (or 4-40) female-female (coupling) nuts; does this seem
correct?
--
Eric Christopherson