Strobe plotter documentation or information?

Hi I was recently given a Strobe 100 plotter, with an S-100 bus interface card, but no information at all about the protocols or commands or other details needed to connect with and use it. I have searched the usual places and cannot find any manuals or details. Does anyone have a manual for the 100 (or the similar models 200 or 260), or even remember enough to help me get this working. My requirements for it are very simple, pen R, L, F and B, plus pen up and pen down are all I need to command it to do, always in single unit steps. I am going to interface this to my 1130 replica as a replacement 1627 plotter (small Calcomp device rebadged by IBM for 1620 and 1130 computers). The 1130 only needed those few commands I listed above from its plotter. Carl ________________________________ This e-mail message, including any attachments, is for the sole use of the person to whom it has been sent, and may contain information that is confidential or legally protected. If you are not the intended recipient or have received this message in error, you are not authorized to copy, distribute, or otherwise use this message or its attachments. Please notify the sender immediately by return e-mail and permanently delete this message and any attachments. Gartner makes no warranty that this e-mail is error or virus free.