28 Dec
2006
28 Dec
'06
6:12 a.m.
Tony Duell wrote:
Anyway, Sharp would not sell be the replacement part.
The official reason
was 'safety' -- apprently there are high voltages inside the copier. Yes,
Ran into that trying to get a new one-way clutch for my Tek Phaser 560.
Even though it's on a bit that sticks out when you pull the paper-pick
mechanism out, apparently it's a workshop job because you need to remove
a cover and then (gasp) *a circuit board*! Woooow!
So of course, I removed the cover, removed the little PCB with the
photosensor thing, removed the pingfsckit end of the shaft and drew off
the one way clutch. The grease had dried into a solid sticky mass, so I
soaked it in some WD40 until I could separate the two bits. Now
Tektronix say it needs to be very special grease (again, only available
to Tek workshops), so I tried Castrol LM since I had a huge tub of it
from rebuilding the suspension arm bearings in my car.
It seems to work
just fine. Oh, saying that it will doubtless seize up again the
next
time I print (Sod's Law) but it takes 10 minutes to sort.
Gordon