8 Jan
2015
8 Jan
'15
9 p.m.
On Wed, Jan 07, 2015 at 05:35:29PM -0500, Alan Hightower wrote:
Does anyone have any past experience reverse
engineering an existing
de-populated PCB into a scan, netlist, or similar? Any lessons learned
positive or negative?
Your many-layer board is far too complex for this wheeze, but back when I was
actually doing electronics for a living, a board I needed to reverse-engineer
was a two-layer affair and so I chucked it onto the office photocopier and
cranked up the enlarger. After a few rounds of re-copying the empty board, I
had several A3 sheets that had high contrast and were big enough to annotate
with components (from inspecting a populated board) and their values. From
there, it became reasonably simple to draw a proper schematic.