AW: Fujitsu M2442AC tape drive and Emulex QT13 controller issues...

Hi Glen, thanks for looking up the settings for me, it would be of great help ! In order to help you quickly : You can find the procedure to start the QT13-diagnostics on page 2-13 of the QT13 manual (to be found on bitsavers.org). Even the switch settings can be read out via the diagnostics menu, so no need to open up your system. Best regards, Pierre ------------------------------------------------------------------------------- Pierre's collection of classic computers : http://classic-computing.dyndns.org/ ________________________________ Von: Glen Slick <glen.slick at gmail.com> An: General Discussion: On-Topic and Off-Topic Posts <cctalk at classiccmp.org> Gesendet: Freitag, den 14. Mai 2010, 19:35:05 Uhr Betreff: Re: Fujitsu M2442AC tape drive and Emulex QT13 controller issues... On Fri, May 14, 2010 at 9:17 AM, P Gebhardt <p.gebhardt at ymail.com> wrote: I have a 2444AC that I have successfully used with a QT13 to install 2.11BSD and RSTS/E on a PDP-11/73. I'm pretty sure I ran the full on-board QT13 tape write/read diagnostics on a scratch tape without any problems at some point. I might have time this weekend to hook the system back up and capture the QT13 configuration and diagnostic output from my system. -Glen