21 Apr
2008
21 Apr
'08
8:22 p.m.
On Mon, Apr 21, 2008 at 12:23 PM, silvercreekvalley
<silvercreekvalley at yahoo.com> wrote:
Just a little more info on the DEC
cabinet, it does appear to have a
part number H9642-DC if that is
of any help.
The side panels do appear to be quite
well 'stuck' and I cant see any obvious
bolts, but I did notice that the cross
bars on the panels have slots (one is
visible).
Did you remove the rear door? After removing the rear door are there
two end panel locking brackets bolted to the bottom rear of the
cabinet, one on the left side and one on the right side, each with two
bolts? They are L shaped with the shorter side of the L bolted to the
cabinet and the longer side projecting backwards from the rear of the
cabinet. You don't need to remove the two bolts completely, just
loosen the two bolts on each bracket and slide the brackets upward to
remove them. Then you can remove the side panels of the H9640 series
cabinet.
I was just stumped by this myself. It wasn't obvious to me that those
two brackets were what was blocking the removal of the side panels. I
have a copy of EK-H9642-IN DEC DATASYSTEMS INSTALLATION MANUAL H9640
SERIES CABINET which what I looked at to figure out how to remove the
side panels of a cabinet I have.