20 Dec
2009
20 Dec
'09
10:25 a.m.
It is a 6 pin IDP connector. Rectangular. One
can make up a tail to
get to it by using a 6 pin IDP and a short ribbon cable.
I don't think it is. I agree it's the same spacing (I thought it was smaller, but I just measured the one on my 6150
monitor), but I don't
think there's room at the ends for the clamps that hold an insulation
displacement block together.
It's polarised by the overlap of the metal shell, and the rubber
moulding around it, not by any of the keys normally found on IDCs.
Since you're the only person likely to be plugging it in, can;'t you just
mark it 'Top' or something?
-tony