4 Jun
2000
4 Jun
'00
5:33 p.m.
The classic way of removing SOJ parts is to use two soldering irons and a
big blob of solder on both rows of pins. The solder blobs heat all the
pins simultaneously and the chip can be slid right off.
Also, you'll be removing the chip without damage -and- you can easily
clean up the PC pads to install a new chip.
It's a great Silicon Valley hack I've see here performed many times.
-Mike
On Sun, 4 Jun 2000, Richard Erlacher wrote:
The solder wick method can work, but one is tempted to
lift up on the pins
to pop the part loose, which will deform them forever. If you're better at
it than I am, you might succeed with that method. The gull-wing parts I've
used after using this extraction method have always been a source of
trouble, needing special care to solder them into a new application.
Dick
----- Original Message -----
From: Chuck McManis <cmcmanis(a)mcmanis.com>
To: <classiccmp(a)classiccmp.org>
Sent: Sunday, June 04, 2000 7:19 PM
Subject: Re: Removing surface-mounted ICs
You use solder wick. You lay it over the pins,
you wick up the solder that
is holding them down. Alternatively you use a suction grabber device and a
very small torch or hot air gun. (the latter is preferred). Attach the
pickup to the top of the chip, then blow the hot air gun on it, and lift
it
off.
--Chuck
At 12:58 AM 6/5/00 +0000, you wrote:
>Can anyone recommend a way of removing surface-mounted ICs (specifically
SOJ