The metal on top of the RX02 assembly is screwed to the rack.
I think it's basically to keep things out of the power supply and off the
contacts to the caps.
It could also be an RF/EMI Shield.
One guy in DEC Field Service neglected to screw it in one day and when I
worked on the VAX
I came in contact with it and the RX02 power supply on the 11/750. I'll
never forget that.
Bill
On 4/6/07, Gooijen, Henk <henk.gooijen at oce.com> wrote:
Pete wrote
Not normally. I've never seen one with anything over the
top, except for one in a tabletop case, of course; and the
drawings don't show anything of the sort. I can't see how
you'd fasten any sort of top cover.
I have RX02's rack-mounted with a top cover.
However, the top cover is *not* attached to the RX02 drive.
It is separately mounted just above the drive in the rack
by 2 standard screws at each side to the vertical post.
Sort of "dust cover".
- Henk.
This message and attachment(s) are intended solely for use by the
addressee and may contain information that is privileged, confidential or
otherwise exempt from disclosure under applicable law.
If you are not the intended recipient or agent thereof responsible for
delivering this message to the intended recipient, you are hereby notified
that any dissemination, distribution or copying of this communication is
strictly prohibited.
If you have received this communication in error, please notify the sender
immediately by telephone and with a 'reply' message.
Thank you for your co-operation.
--
--
d|i|g|i|t|a|l had it THEN. Don't you wish you could still buy it now!
pechter-at-gmail.com