3 Jun
2012
3 Jun
'12
10:45 p.m.
Ethan Dicks wrote:
On Thu, May 24, 2012 at 1:55 PM, Ethan Dicks
<ethan.dicks at gmail.com> wrote:
There is a manual for the UC07/08 on the net, it is one of the first hits
when you try to google. Haven't found anything regarding differences
between versions jet....
On Thu, May 24, 2012 at 11:44 AM, Glen Slick
<glen.slick at gmail.com> wrote:
> I have an SQ3706A, REV H, firmware REV L.
OK... looking at my hardware...
The UC07 has a paper-label on the EPROM marked G143M and the 40-pin
chip with the serial number and barcode says "Rev F" (there's a "Rev
D" written on the board in Sharpie up by the SCSI connector).
My Dilog boards are, according to the paper labels in the upper-left
corner, SQ3703As. One is marked Rev G and looks clean. The other is
a Rev E with a few green ECO wires (the Rev E board has an EPROM
marked "Rev G", and the Rev G board has firmware marked "Rev H".
I'm guessing there isn't a lot of info out there to attempt to see if
it's possible to "convert" an SQ3703A to an SQ3706A in the field, but
if anyone knows anything about both boards, I'd be game to try if it's
EPROMs or PALs or whatever.
-ethan
Found almost nothing for them.
I have a board LAbeled SQ703 where the 03 is on a paper label and the SQ7
is printed on the board. Have repaired it sometime, it is working as TMSCP
controller. It has an 10pin Connector for an Terminal to set it up on the
Interface connector side. I remember that I put the rom image from a 706 on
it (shadoo sent me one) but it doesn't work as 706.
I know that there is a 739 that can make both, MSCP and TMSCP...
Regards,
Holm
--
Technik Service u. Handel Tiffe, www.tsht.de, Holm Tiffe,
Freiberger Stra?e 42, 09600 Obersch?na, USt-Id: DE253710583
www.tsht.de, info at tsht.de, Fax +49 3731 74200, Mobil: 0172 8790 741