30 Apr
2019
30 Apr
'19
5:50 a.m.
emanuel stiebler via cctalk wrote:
On 2019-04-29 13:11, Carlos E Murillo-Sanchez via
cctalk wrote:
Interesting... I fired it up to run this command, and now it won't
finish booting, it gets stuck at the
?? ? %DECnet-I-LOADED, network base image loaded, version = 05.0D.00
message...? I do remember running the command and I did not notice any
strange
error counts...
Will try a conversational boot later.? If not, I'll try to restore it
Dear ccmp'ers:
For a while now, I noticed that my vaxstation 4000/60 with OpenVMS 7.2
had become sluggish, but I had not had the time to investigate the
problem.?? The system is mostly idle, RAM is mostly free (there's 32mb),
there is almost no paging, but the CPU is spending upwards of 70% of the
time in the interrupt stack mode.? Currently, I am running it headless
because I have not had the time to fix the monitor (it still has the
framebuffer inside, but this sluggishness issue was present before with
the monitor attached).? I have read that this can be caused by "faulty
i/o devices that interrupt the cpu continuously".? What else can be done
to locate the source of the problem?
SHOW DEV? doesn't show anything weird?
from tape.
carlos.