15 May
2007
15 May
'07
6 p.m.
r.stricklin wrote:
I have what I assume is the bracket (at least for the
QIC-11 drive; it
gets the drive to where the cutout in the front panel is) but there
are no obvious holes in the top shelf to fasten it to. I'm kind of
baffled that there would be a different chassis for a diskless
workstation or that they expected the addition of mounting holes to
be an FCO...
Is there supposed to be ANOTHER bracket, which I would then definitely
be missing?
I'm going from memory, haven't had time yet to pull the 2/120 out and
take pictures....
MT02? here
------------------- QIC
disk | disk tape drive
here | here here
=======================================
This sits on (and I think is screwed to) the top shelf inside the
cabinet. I'm thinking the screws are along the edge of the shelf so
you can get at them easily having taken the side panel off.
The disks in mine are 5.25" full-height 85MB MFM units, there's an
ACB4000 mounted elsewhere in the case for them. You don't get to use
actual SCSI disks until SunOS 4.0, remember.
I can't remember if that board on top is an MT02 or SC4000, just that
it's for the tape drive.
-Frank McConnell